IST-501 iStrep A
Dipstick Waived
Sensitivity 97%
Specificity 95% Kit components
25 Test Strips
25 Extraction Tubes
25 Swabs
1 Procedure Card
1 Reagent A
1 Reagent B
1 Positive Control
1 Negative Control |
Procedure Read Procedure before running test. Refer to Package Insert for details.
 
- Holding bottles upright, add 4 Drops of Reagent A, then 4 Drops of Reagent B to Tube
- Tap bottom of Tube to mix
 
- Add Swab to Tube
- Rotate Swab 10 times in Tube
- Let stand 1 minute
- To remove Swab from Tube:
Press Swab against inside of Tube & squeeze Tube while removing Swab so most of liquid stays in Tube
 
- Place Test Strip in Tube
- Liquid should be at or just below MAX Line
- Read result at 5 minutes
|
| |
Interpretation of Results
 |
|
|
IST-502
iStrep A Cassette
Moderate
Sensitivity 97%
Specificity 95%Kit components
25 Test Strips
25 Extraction Tubes
25 Swabs
1 Procedure Card
1 Reagent A
1 Reagent B
1 Positive Control
1 Negative Control |
Procedure Read Procedure before running test. Refer to Package Insert for details.
- Holding bottles upright, add 4 Drops of Reagent A, then 4 Drops of Reagent B to Tube
- Tap bottom of Tube to mix
- Add Swab to Tube
- Rotate Swab 10 times in Tube
- Let stand 1 minute
To remove Swab from Tube:
Press Swab against inside of Tube & squeeze Tube while removing Swab so most of liquid stays in Tube
 
- Add 3 drops
- Read results at 5 minutes
|
| |
|
|
|
IST-502T
iStrep A Twist
Waived
Sensitivity 90%
Specificity 94%Kit components
25 Test Strips
25 Swabs
1 Procedure Card
1 Reagent A
1 Reagent B
1 Positive Control
1 Negative Control
On-Board
Extraction
Chamber |
 
PROCEDURE Remove Test Device from the foil pouch. Place Test Device on a clean, dry, level surface. Make sure that the device is in the Closed Valve Position, as shown in image above.
|
 |
1. Holding bottles upright, add 5 drops of Reagent , then add 5 drops of Reagent B to Chamber. |
|
2. Add Swab to Chamber, Agitate Swab vigorously in the solution 10 times. Let stand 1 minute.
|
|
3. To Remove Swab:
- Hold down Chamber with thumb and index finger.
- Lift Swab halfway up the Chamber and press against the ribs inside the wall of the Chamber
- Rotate Swab 5 times while pressing firmly against ribs to extract liquid.
- Discard Swab.
|
|
4. Hold down device on a flat surface. Open Valve by twisting ribbed part of Valve clockwise until it stops (Open Valve Position).
Begin timer. Read results at 5 minutes.
|
|
| |
|
